It takes about 6 weeks from the time you select your rod design to receive your finished rod. This is dependent on rod blanks and components being in stock. NFC blanks are usually not in stock and can take an extra 4-8 weeks.

Yes! We have more than a hundred thread and paint colors available. For best results, please send the item (like a reel). Or provide multiple photos of the item in both artificial and natural light.

Most rods cost between $295 and $500 plus shipping. Price is determined based on the cost of components plus time. Custom paint, fancy wraps, and longer rods take more time.

We take the Made in the USA label seriously. It requires all components be made in the USA AND materials be sourced from the USA. This is difficult to achieve (cork handles are out). We source what materials we can from U.S. manufacturers, and we will note in the description if a rod blank is Made in the USA.

Any defects in workmanship or rod blanks should be seen in one year of normal use. Since we are not the rod blank manufacturer and these are not production rods, we cannot just send a new rod. Original components may not be available. If repairs are needed beyond a year, we can repair at a reasonable rate plus shipping. See our Warranty section.

Our paint is airbrushed for even coverage and low additional weight. The paint has an additive made to adhere to hard surfaces like graphite. The paint is then sprayed with a high-gloss (or matte) finish which provides UV protection for the paint. Both the paint and finish are flexible with the rod. The result adds minimal weight and is durable for normal contact with hard surfaces. It has been tested whacking against the side of an aluminum boat, concrete floor, and other rods without visible scratching. It can scratch or chip with rubbing against sharp rocks, hook points, or ballistic lead weights. For maximum durability a thin coat of epoxy rod finish can be applied over the top.